Speedtouch (Thomson, Technicolor) SNMP Guide
- Cerberus Networks Support (Unlicensed)
The following details the steps you need to make your router ready for use with the Cerberus NetSTATS broadband monitoring service.
It is recommended that you connect your computer directly to the device to make the configuration changes. This may require you to change the IP address of your computer to be able to contact the router on its management IP. Please review configuration support documentation for your own operating system on how to do this.
Once connected to the router follow the steps below. The lines of configuration you need to add are as follows for NAT or bridged (depending on your requirements. Edit the text in a text editor to replace the text in blue with your own values as appropriate before you use it in the steps below.
NAT Configuration
:system config upnp=disabled
:service system ifadd name=PING_RESPONDER group=wan
:service system ifadd name=TELNET group=wan
:service system ifadd name=HTTPs group=wan
:service system ifadd name=HTTP group=wan
:service system ifadd name=SNMP_AGENT group=wan
:mlp role addpriv name=Administrator access=anyaccess service=anyservice
:ids config state=disabled
:service system modify name=SNMP_AGENT state=enabled log=disabled
:snmp community add securityname=ROCommunity communityname=ENTER YOUR SNMP COMMUNITY HERE
:connection bind application LOOSE(UDP) port 161
:firewall config state disabled
:system config digestauth=disabled
:user config name=Administrator password=ENTER YOUR PASSWORD HERE
:saveall
:exit
Bridge Configuration
:eth bridge config filter=none
:ip ipadd intf=LocalNetwork addr=ENTER YOUR IP ADDRESS HERE/ENTER YOUR SUBNET MASK HERE
addroute=enabled
:ip rtadd dst=0.0.0.0 dstmsk=0.0.0.0 gateway= ENTER YOUR GATEWAY ADDRESS HERE
:system config upnp=disabled
:service system ifadd name=PING_RESPONDER group=wan
:service system ifadd name=TELNET group=wan
:service system ifadd name=HTTPs group=wan
:service system ifadd name=HTTP group=wan
:service system ifadd name=SNMP_AGENT group=wan
:mlp role addpriv name=Administrator access=anyaccess service=anyservice
:ids config state=disabled
:service system modify name=SNMP_AGENT state=enabled
:snmp community add securityname=ROCommunity communityname=ENTER YOUR SNMP COMMUNITY HERE
:firewall config state disabled
:system config digestauth=disabled
:connection bind application LOOSE(UDP) port 161
:user config name=Administrator password=ENTER YOUR PASSWORD HERE
:saveall
:exit
Procedure
Open the Windows command prompt. You can do this by clicking on Start, then Run and type in cmd and then press enter, a black window will appear. When the black window appears please type:
telnet 192.168.1.254
and then please press enter. Note if you have changed the LAN IP of your router, please substitute the new IP in place of 192.168.1.254 above.
2. You will see the login prompt below. Enter the details as follows
Username: Administrator
Password: Leave the password blank
Note if you have changed the Administrator password of your router, please enter it.
3. Once you are logged into the telnet console copy the text provided with this guide for the NAT or Bridged configuration (depending on which is suitable for your connection), into the clipboard and paste it into the telnet console by right-clicking the mouse and choosing Paste.
You should then see the text from the document appear in the telnet screen similar to the picture below. The last command (exit) will close the session to the router. You can then close the command window.
